Drill bit sized to fit your skewers snugly, approximately 3 mm
Ingredients
Wooden boardabout 1.8 cm (¾ inch) thick
Bamboo skewers
Wood glue for the front-facing version
Paintoptional
Googly eyesoptional
Craft foam for the beak and wattle, optional
Craft glue for the decorations, optional
Instructions
For the front-facing turkey, draw a rounded body with a flat bottom, a separate bowling-pin-shaped head and neck, and a stand with a flat bottom and rounded top. Make the stand about 3–4 inches wide and 1 inch tall.
Draw a slot in the bottom center of the body and the top center of the stand. Each should be about 1 cm deep and as wide as your board is thick.
Cut out the pieces and slots with a jigsaw. Sand the edges smooth.
Slide the stand into the body. Adjust the slots until the holder stands upright without wobbling.
Test your drill bit with a skewer in scrap wood. Drill holes about 1 cm deep along the body’s curved top edge, angling them to spread the skewers into a fan. Add holes near the edges of the front and back faces if desired, taking care not to drill through the wood.
Insert empty skewers to check their fit and arrangement. Remove them before decorating.
Paint the turkey if desired. Add googly eyes and a craft foam beak and wattle, or paint the face.
With the stand in place, position the head against the front of the body, keeping the stand clear. Attach with wood glue. Rubber bands can help hold the pieces while the glue dries.
Once the glue and any paint have fully dried, place the holder on a stable surface. Add food-filled skewers evenly on both sides to form the tail.
Notes
For the side-facing version, cut the head, neck, and body as one silhouette. Make and fit a separate stand, then drill and decorate as above. No separate head piece is needed.Skewer ingredient ideas include grapes, blueberries, cherry tomatoes, olives, cucumber, bell pepper, firm fruit, cheese, ham, and cured sausage. Small cookie cutters work well for cutting decorative shapes from thick slices.Print the optional template at 100% / Actual Size. Check the measurement square and adjust the slots to match your wood.Allow additional time for glue and paint to dry.In either case, you'll need to cut a slit in the wood around 1cm high and with the same width as the wooden board you're using in the center of the bottom. Make a slit with the same characteristics in the top of the stand piece too. The stand piece should be rounded at the top and flat on the bottom and should measure around 3-4 inches long.